| Sample Request Sheet | ||
| MOTOR SIZE (LENGTH） | □ ｍｍ MAX. mm | |
| ELECTRICAL SPECIFICATIONS | ||
| PHASE ON METHOD | Constant current (chopper) driver IC name （CONST. CURRENT（CHOPPER） |
Constant voltage （CONST. VOLTAGE） |
| EXCITATION METHOD |
□2-2P □1-2P □W1-2P □OTHERS |
マイクロステップ駆动 □Yes □No |
| DRIVE METHOD | □Bipolar (BI-POLAR) |
Unipolar (UNI-POLAR) Number of lead wires (LEADWIRES) □5 □6 □8 |
| STEP ANGLE | □0.36°(5P) □0.72°(5P) □1.2°（3P） □0.9°（2P） □1.8°（2P） | □OTHERS（ ） |
| DRIVE VOLTAGE | V（DC) | |
| DRIVE CURRENT | mA [Phase]□（PEAK) | |
| WINDING RESISTANCE | Ohm [Phase] AT25°Ｃ | |
| HOLDING TORQUE | mNm MIN. PPS | TWO PHASE ON |
| PULL OUT TORQUE) | mNm MIN. PPS | RPM |
| mNm MIN. PPS | RPM | |
| PULL IN TORQUE | mNm MIN. PPS | RPM |
| INRETIA LOAD (gcm2) | mNm MIN. PPS | RPM |
| MECHANICAL SPECIFICATIONS | ||
| SHAFT LENGTH | LS= mm (Front) mm(Rear) | |
| SHAFT DIAMETER | LD= φ mm (Front) mm (Rear) | |
| □Ｄcut | Length＝ mm (Front) mm (Rear) | Width = mm |
| □Hole | Hole diameter Φ = mm Position mm | （From The Tip） |
| CONNECTOR / TUBE / TIE / CORE SPECIFICATION | ||
| LEAD WIRE LENGTH | LW= mm UL( ) AWG ( ) | |
| CONNECTOR TYPE | MAKER： | |
| HSG P/No. ： | PIN ASSIGNMENT PIN NO. PHASE |
|
| PIN P/No. ： | 1 | |
| 2 | ||
| 3 | ||
| SPECIAL OTHERS | 4 | |
| 5 | ||
| 6 | ||
